Replace the weak factory skid cover on the center axle disconnect for your Jeep JL Wrangler or JT Gladiator Truck and upgrade from the small factory steering damper with a specifically tuned RockSport RED Steering Stabilizer; the stabilizer mounts relocate the damper up and out of harm's way.
Features
- CAD/FAD Skid Plate
- Black Anodized Billet Aluminum Tie Rod Mount
- Axle Side Damper Mount
- RockSport Specifically Tuned Steering Damper
- 3/16" Laser-Cut Steel
- Gold Zinc Finish
- Made In The USA
A 3/16" Skid Plate adds needed protection for the center axle disconnect while the stabilizer relocation brackets mount the upgraded RockSport steering stabilizer up to a safer location. This is a complete kit that bolts into factory locations providing more protection and additional performance for your Jeep.
The tie rod mount is a two-piece aluminum billet design, is simple to install, and allows you to position the stabilizer for maximum performance. Finished in anodized black with a laser-engraved "M" around the recessed bolt holes for a clean and custom look.
Specifications
- Compatibility: 2018+ JL Wrangler & 2020+ JT Gladiator (Minimum 2" Lift Required)
- Front Axle Disconnect Skid Plate: 3/16" Hot-Rolled Steel Plate
- Tie Rod Mount: 2" x 3" 6061-T6 Aluminum Black Anodized
- Stabilizer Mount: 3/16" Hot-Rolled Steel Plate
- Stabilizer Valving: 9-Stage Coil Spring
- Stabilizer Piston Rod: 14mm (stronger than stock)
- Stabilizer Elastomer Dust Boot: Protects from stone damage
- Stabilizer Piston & Bore: 35mm (increased oil volume)
- Stabilizer Tube Design: Twin Tube (Protects internals against stone damage)
- Stabilizer Lip Seal: Multiple Seal (prevents oil loss)
- Coating: Gold Zinc
Installation
- Difficulty: Easy
- Body Modification: None
- Time to Install: 1-2 Hours
Important Notes
- Factory Tie Rod: The billet tie rod mount does NOT work with factory tie rod.
- Requirements: Minimum 2" lift required.
- Left-Hand Drive: The RockSport steering stabilizer kit works with left-hand drive applications only.
- Clearance: Raised steering stabilizer requires at least 2" of bump stop to clear frame.
- Billet Mount: MetalCloak highly recommends using anti-seize on all bolts.
MetalCloak part #: 6374
